HEIDENHAIN MANUALPLUS 620 - Program Section Repeat Unit

HEIDENHAIN MANUALplus 620 141
2.11 Units—Special Operations
"Program section repeat" unit
Use the Repeat unit to program a program section repeat. The unit
consists of two inseparable parts. Program the unit with the Begin
form immediately before the repeatable part, and the unit with the End
form immediately behind the repeatable part. Be sure to use the same
variable number here.
Unit name: REPEAT / Called cycle: None
“Start” form
AE Repetition
 0: Beginning
 1: End
V Variable number 1–30 (counting variable for the iteration
loop)
NN Number of repetitions
QR Save workpiece blank
 0: No
 1: Yes
K Comment
“End” form
AE Repetition:
 0: Beginning
 1: End
V Variable number 1–30 (counting variable for the iteration
loop)
Z Additive datum shift
K Comment