HEIDENHAIN MANUALPLUS 620 - Reading General Nc Information

HEIDENHAIN MANUALplus 620 359
4.31 Programming with Variables
Reading general NC information
Use the following syntax to read general NC information.
Active operating mode
#i1 Active operating mode:
 2: Machine
 3: Simulation
Active unit of measure
#i2 Active unit of measure:
 0: Metric [mm]
 1: Inches [in]
Languages
#i8 Available languages:
 0: ENGLISH
 1: GERMAN
 2: CZECH
 3: FRENCH
 4: ITALIAN
 5: SPANISH
 6: PORTUGUESE
 7: SWEDISH
 8: DANISH
 9: FINNISH
 10: DUTCH
 11: POLISH
 12: HUNGARIAN
 14: RUSSIAN
 15: CHINESE
 16: CHINESE_TRAD
 17: SLOVENIAN
 18: ESTONIAN
 19: KOREAN
 20: LATVIAN
 21: NORWEGIAN
 22: ROMANIAN
 23: SLOVAK
 24: TURKISH
 25: LITHUANIAN
Identification codes for tool information
#i1 Active operating mode (see table at right)
#i2 Active unit of measure (inches/metric)
#i3 G30 active = 1
#i4 G16 active = 1 (currently not used)
#i5 Last programmed T number
#i6 Start block search active = 1
#i7 System is DataPilot = 1
#i8 Selected language