HEIDENHAIN MANUALPLUS 620 User Manual

HEIDENHAIN MANUALplus 620 345
4.27 Engraving Cycles
4.27 Engraving Cycles
Character set
The MANUALplus can realize the characters listed in the following
table. The text to be engraved is entered as a character string.
Diacritics and special characters that you cannot enter in the editor can
be defined, character by character, in NF. If text is defined in “ID” and
a character is defined in “NF,” the text is engraved before the
character.
Small letters Capital letters
Numerals,
diacritics
Special
characters
NF Character NF Character NF Character NF Character Meaning
97 a 65 A 48 0 32 Blank space
98 b 66 B 49 1 37 % Per cent sign
99 c 67 C 50 2 40 ( Opening parenthesis
100 d 68 D 51 3 41 ) Closing parenthesis
101 e 69 E 52 4 43 + Plus character
102 f 70 F 53 5 44 , Comma
103 g 71 G 54 6 45 – Minus sign
104 h 72 H 55 7 46 . Point
105 i 73 I 56 8 47 / Forward slash
106 j 74 J 57 9 58 : Colon
107 k 75 K 60 < Less than character
108 l 76 L 196 Ä 61 = Equal sign
109 m 77 M 214 Ö 62 > Greater than character
110 n 78 N 220 Ü 64 @ at
111 o 79 O 223 ß 91 [ Opening brackets
112 p 80 P 228 ä 93 ] Closing brackets
113 q 81 Q 246 ö 95 _ Underscore
114 r 82 R 252 ü 8364 Euro sign
115 s 83 S 181 µ Micro
116 t 84 T 186 ° Degrees
117 u 85 U 215 * Multiplication sign
118 v 86 V
119 w 87 W
120 x 88 X
121 y 89 Y
122 z 90 Z

HEIDENHAIN MANUALPLUS 620 Specifications

General

Brand	HEIDENHAIN
Model	MANUALPLUS 620
Category	Control Systems
Language	English