20
6.1 Units—“Turning” Group ..... 436
“Roughing” group ..... 436
“Finishing” group ..... 436
“Recessing” group ..... 437
“Thread” group ..... 437
6.2 Units—“Drilling” Group ..... 438
“Centric drilling" group ..... 438
“ICP drilling, C axis” group ..... 438
“C-axis face drilling” group ..... 438
“C-axis lateral surface drilling” group ..... 439
6.3 Units—”Predrilling in C Axis” Group ..... 440
“Predrilling in C-axis, face” group ..... 440
“Predrilling in C-axis, lateral surface” group ..... 440
6.4 Units—”Milling in C Axis” Group ..... 441
“Milling in C-axis, face” group ..... 441
“C-axis lateral surface milling” group ..... 442
6.5 Units—”Drilling, Predrilling in Y Axis” Group ..... 443
“ICP drilling, Y axis” group ..... 443
“Predrilling in Y axis” group ..... 443
6.6 Units—”Milling in Y Axis” Group ..... 444
“Milling in XY plane” group ..... 444
“Milling in YZ plane” group ..... 445
6.7 Units—“Special Units” Group ..... 446
6 Overview of Units ..... 435
To Next Page
Loading...
