93
QC Test Reminder settings
Reminder
0.50.50.5
Hours
2
3
1
4
FIGURE 3-76
When the Reminder Time button is pressed
in the QC Test menu (see FIGURE 3-67), the
settings for the QC reminder based on time
is displayed. A reminder message will be
shown at this set time, prior to QC lockout.
The Reminder time can be set to no more
than half the shortest of the QC lockout
times, irrespective as to which level this
refers.
The current value of the reminder time(2)
expressed in the given unit(1) is displayed.
a) Set the reminder time using the Scroll bar
arrows(3).
To turn the Reminder Time function o, set
the value(2) to “0”.
b) Press the Confirm button(4). FIGURE
3-78 will be displayed.
1 Unit for reminder time
2 Reminder time value
3 Scroll bar arrows
4 Confirm button
To Next Page
Loading...
