To Next Page

To Previous Page

the congured authencaon mode. By default, the authencaon mode is Controller.

This mode is applicable to edit users' authencaon modes in batch.

• If an user needs to use a special

authencaon mode, which is dierent from the

authencaon mode congured in Set System Parameters , he can use card/ngerprint,

card, etc. The system will authencate the user's identy according to the congured

authencaon mode rst. This mode is applicable to edit single user's authencaon

mode, which has special permissions.

Role

Select the user's role as administrator or normal user.

• Admin: The admin has all permissions to operate the device.

• User: The normal user can check

aendance on the inial page.

Note

• All persons can enter the main page by entering the device password to operate if there is

no admin user congured.

• Aer conguring the admin, you should authencate the admin to enter the main page.

• You can use the USB interface to import the user

informaon. For details, see Data

Transfer.

3. Press ESC, and select Yes to save the sengs and exit the page.

7.5.2 Manage Person (Search/Edit/Delete)

Search, edit, delete the added users. You can also manage added ngerprints, manage user's cards.

Search User

Move the cursor and select User → User to enter the user list.

Enter the user's name or employee ID in the search box, and press OK to start search.

Edit User

Move the cursor and select User → User to enter the user list. Select an user in the list and press

OK.

Select Edit User and refer to Add Person to edit the user's

informaon.

Press ESC, and select Yes to save the sengs.

Delete

You can delete user, delete password, clear ngerprint, and clear card.

Delete User

Delete the selected user.

Clear FP

Clear the all added ngerprints of the selected user.

DS-K1T804B Series Fingerprint Access Control Terminal User Manual

HIKVISION DS-K1T804B Series User Manual

Questions and Answers: