To Next Page

To Previous Page

Sleeping

Set the device sleeping waing me (minute). When you are on the inial page and if you set

the sleeping me to 30 min, the device will sleep aer 30 min without any operaon.

Note

If you set the sleeping me to 0, the device will not enter sleeping mode.

Wait to Logout

If there is no operaon within the congured me, the system will logout.

Record over Threshold Prompt

If the aendance record memory reaches the congured value, the system will pop up a

prompt to remind you. The available value is from 1 to 99.

Note

Up to 50,000 aendance records can be saved.

Auth Mode (Authencaon Mode)

The authencaon mode can be switched among "Card/FP (ngerprint)", "Card", "FP

(ngerprint)", "Card & Password", "Card & FP (ngerprint)", "FP (ngerprint) & Password",

"Card & FP (ngerprint)" & "Password", and "ID (employee ID) and password".

Record Delete

When the

funcon is enabled, the system will remind you to delete records. The system will

delete the rst 3000 aendance records when the memory reaches the congured

threshold, in order to save the new aendance records. By default, the funcon is enabled.

For details, see

Aendance Record Deleng Rule .

Language

Change the system language. Aer you change the system language, the device will reboot

automacally.

4. Press ESC and select Yes to save the sengs and exit the page.

7.10.4 System Upgrade

You can upgrade the system online or locally. The system reads the upgrading le in the plugged

USB

ash drive or gain the upgrading package from the plaorm to upgrade the device.

Steps

1. Move the cursor and select System → Upgrade .

2. Upgrade the system.

Local Upgrade: Plug the USB

ash drive to the USB interface. Press OK. The system will read

the digicap.dav

le and upgrading automacally. Aer the upgrading is completed, the

device will reboot automacally.

DS-K1T804B Series Fingerprint Access Control Terminal User Manual

HIKVISION DS-K1T804B Series User Manual

Questions and Answers: