HIKVISION DS-K1T804B Series - Restore Settings; Log Query

Note
• The upgrading
le should be in the root directory.
• The upgrading le name in the USB ash drive should be digicap.dav.
• Do not power
o during the device upgrading.
• Aer the upgrading is completed, remove the USB ash drive.
-
Online upgrade: The system will gain the upgrade package from the plaorm to upgrade.
7.10.5 Restore Sengs
Restore system parameters to factory sengs or default sengs.
Steps
1. Move the cursor and select System → Reset .
2. Press OK to enter the Reset page.
Figure 7-32 Reset Page
3. Select Factory Sengs or Default Sengs.
Factory Sengs
All parameters of the device will restore to the factory parameters.
Default Sengs
All parameters, excluding the communicaon parameters, the remote user management,
and events, will restore to the factory parameters.
4.
Conrm sengs in the prompt page and the device starts restoring.
7.10.6 Log Query
You can search the authencaon logs via the user's employee ID, name, or card.
Steps
1. On the Home page, move the cursor and select Log.
DS-K1T804B Series Fingerprint Access Control Terminal User Manual
52