To Next Page

To Previous Page

8.2.14 Issue Cards to Persons in Batch

The client provides a convenient way to issue cards to mulple persons in a batch.

Steps

1. Enter Person module.

2. Click Batch Issue Cards.

All the added persons with no card issued will display.

3. Set the card issuing parameters. For details, refer to Set Card Issuing Parameters .

4. Click

Inialize to inialize the card enrollment staon or card reader to make it ready for issuing

cards.

5. Click the card number column and enter the card number.

Place the card on the card enrollment staon.

Swipe the card on the card reader.

Enter the card number manually and press Enter key on your keyboard.

The card number will be read

automacally and the card will be issued to the person in the list.

6. Repeat the above step to issue the cards to the persons in the list in sequence.

8.2.15 Report Card Loss

If the person lost his/her card, you can report the card loss so that the card's related access

authorizaon will be inacve.

Steps

1. Enter Person module.

2. Select the person you want to report card loss for and click Edit to open the Edit Person

window.

3. In the

Credenal → Card panel, click on the added card to set this card as lost card.

Aer reporng card loss, the access authorizaon of this card will be invalid and inacve. Other

person who gets this card cannot access the doors by swiping this lost card.

Oponal: If the lost card is found, you can click to cancel the loss.

Aer cancelling card loss, the access authorizaon of the person will be valid and acve.

5. If the lost card is added in one access group and the access group is applied to the device

already,

aer reporng card loss or cancelling card loss, a window will pop up to nofy you to

apply the changes to the device. Aer applying to device, these changes can take eect on the

device.

8.2.16 Set Card Issuing Parameters

The client provides two modes for reading a card's number: via card enrollment staon or via the

card reader of the access control device. If a card enrollment

staon is available, connect it to the

DS-K1T804B Series Fingerprint Access Control Terminal User Manual

HIKVISION DS-K1T804B Series User Manual

Questions and Answers: