HIKVISION DS-K1T804B Series - Set Manual Attendance

08:00, and check out's schedule as Monday 17:00, the valid person's authencaon before
17:00 on Monday will be marked as check in. And the valid person's authencaon aer 17:00
on Monday will be marked as check out.
5. Press ESC and save the
sengs.
Result
Enter the inial page, the current aendance mode will be displayed on the page. When you
authencate on the inial page, the authencaon will be marked as the congured aendance
status according to the congured schedule.
7.7.2 Set Manual Aendance
Set the aendance mode as manual, and you can select a status manually when you take
aendance.
Before You Start
Add at least one person, and set the person's authencaon mode. For details, see Person
Management .
Steps
1. Move the cursor and select System → A. Status to enter the Aendance Status page.
2. Move the cursor and select
Aendance Mode and set the aendance mode as Manual.
Figure 7-15 Manual Mode
Note
Make sure the aendance status is enabled. By default, it is enabled.
3. Press ESC and save the aendance mode.
4. Move the cursor and select Shortcut Key and dene the shortcut key's aendance status.
5. Press ESC and save the sengs.
DS-K1T804B Series Fingerprint Access Control Terminal User Manual
35