HIKVISION DS-K1T804B Series - 7.3 Local Login; 7.4 Communication Settings

according to the congured authencaon mode. By default, the authencaon mode is
Controller. This mode is applicable to edit users' authencaon modes in batch.
• If an user needs to use a special
authencaon mode, which is dierent from the
authencaon mode congured in Set Access Control Parameters , he can use card/
ngerprint, card, etc. The system will authencate the user's identy according to the
congured authencaon mode rst. This mode is applicable to edit single user's
authencaon mode, which has special permissions.
Role
Select the user's role as administrator or normal user.
• Admin: The admin has all permissions to operate the device.
• User: The normal user can check
aendance on the inial page.
Note
• All persons can enter the main page by entering the device password to operate if there is
no admin user congured.
• Aer conguring the admin, you should authencate the admin to enter the main page.
• You can use the USB interface to import the user
informaon. For details, see Data
Transfer.
3. Press ESC, and select Yes to save the sengs and exit the page.
7.3 Local Login
Log in the device as an administrator to mange the device parameters, including the
communicaon, the user, the access control parameters, the aendance, the me, the report, the
system, etc.
Hold OK for 3 s to enter the login page. Select FP, Device PWD, or Card, and authencate to enter
the home page.
Note
• Press the up or down key on the keypad to change the input method.
• The login page varies depending on
dierent device model. When operaon, refer to the actual
device page.
7.4 Communicaon Sengs
Set device network, EHome, Hik-Connect service, etc.
DS-K1T804B Series Fingerprint Access Control Terminal User Manual
18