To Next Page

To Previous Page

View Info.: View the user's added card informaon.

Note

• The card No. is required.

• Up to 20 digits can be contained in the card No.

• The card No. can be 0.

• The card No. can start with 0 when it contains more than one numbers. E.g. 012345.

• The card No. should be used for once.

• If device does not support swiping card, you should enter the card No. manually. If you

need to enter the card No. manually, you should enable Press Key to Input Card No.. For

details, see

Congure Parameters for Access Control Device .

FP (Fingerprint)

On the Fingerprint page, select a target nger and record according to the voice prompt.

Note

• The same

ngerprint cannot be repeatedly added.

• Up to 10 ngerprints can be added to one user.

• You can also scan the

ngerprints via the external ngerprint recorder and apply the

ngerprints to the device by the client soware.

• For detailed

informaon about scanning the ngerprint, see Tips for Scanning Fingerprint .

Dept. (Department)

Select a department in the list and edit the department.

Note

For detailed informaon about eding the department, see .

Plan (Template)

Move the cursor and select Set and select a template from the list.

Note

For details about eding template, see Set Schedule Template .

Auth.

Select an authencaon mode when verifying user's permission.

Note

• If you select the

authencaon mode as Controller, you should set the authencaon

mode in Set Access Control Parameters . The system will authencate user's identy

DS-K1T804B Series Fingerprint Access Control Terminal User Manual

HIKVISION DS-K1T804B Series User Manual

Questions and Answers: