HIKVISION DS-K1T804B Series User Manual

Result
Press a key on the keypad to select an aendance status and authencate. The authencaon will
be marked as the congured aendance status according to the dened shortcut key.
Or when you
authencate on the inial page, you will enter the Select Status page. Select a status
to take aendance.
Note
If you do not select a status for about 20 s, the authencaon will be failed and it will not be
marked as a valid aendance.
7.7.3 Set Manual and Auto Aendance
Set the aendance mode as manual and auto and the system will auto change the aendance
status according to the congured parameters. At the same me you can manually change the
aendance status before the authencaon.
Before You Start
Add at least one person, and set the person's
authencaon mode. For details, see Person
Management .
Steps
1. Move the cursor and select System →
A. Status to enter the Aendance Status page.
2. Move the cursor and select Aendance Mode and set the aendance mode as Manual and
Auto.
Figure 7-16 Manual and Auto Mode
Note
Make sure the aendance status is enabled. By default, it is enabled.
3. Press ESC and save the aendance mode.
DS-K1T804B Series Fingerprint Access Control Terminal User Manual
36

HIKVISION DS-K1T804B Series Specifications

General

Brand	HIKVISION
Model	DS-K1T804B Series
Category	IP Access Controllers
Language	English