HIKVISION DS-K1T804B Series User Manual

Chapter 8 Client Soware Conguraon
8.1 Add Device
The client provides three device adding modes including by IP/domain, IP segment, and ISUP
protocol. The client also supports imporng mulple devices in a batch when there are large
amount of devices to be added.
8.1.1 Add Online Device
The acve online devices in the same local subnet with the client soware will be displayed on the
Online Device area. You can click Refresh Every 60s to refresh the
informaon of the online
devices.
Add Single Online Device
You can add single online device to the client soware.
Steps
1. Enter the Device Management module.
2.
Oponal: Click on the right of Device Management and select Device.
3. Click Online Device to show the online device area.
The searched online devices are displayed in the list.
4. Select an online device from the Online Device area.
Note
For the inacve device, you need to create the password for it before you can add the device
properly. For detailed steps, refer to Acvaon .
5. Click Add to open the device adding window.
6. Enter the required
informaon.
Name
Enter a descripve name for the device.
Address
The IP address of the device is obtained automacally in this adding mode.
Port
The port number is obtained automacally.
User Name
By default, the user name is admin.
DS-K1T804B Series Fingerprint Access Control Terminal User Manual
55

HIKVISION DS-K1T804B Series Specifications

General

Brand	HIKVISION
Model	DS-K1T804B Series
Category	IP Access Controllers
Language	English