HIKVISION DS-K1T804B Series User Manual

9.7 Network Parameters Sengs
Set device network parameters, including the NIC type, DHCP, and HTTP.
On the Device for Management page, click → Network → Network Parameters to enter the
Network Parameters Sengs tab.
NIC Type
Select a NIC type from the drop-down list. You can select either
Self-adapve, 10M, or 100M.
DHCP
If you disable the funcon, you should manually set the device's IPv4 address, IPv4 subnet
mask, IPv4 default gateway, MTU, and port.
If you enable the
funcon, the system will automacally assign IPv4 address, IPv4 subnet mask,
IPv4 default gateway for the device.
HTTP
Set the HTTP port, DNS1 server address, and DNS2 server address.
9.8 Report Strategy
Sengs
You can set the center group for uploading the log via the EHome protocol.
On the Device for Management page, click
→ Network → Report Strategy to enter the Report
Strategy Sengs tab.
You can set the center group and the system will transfer logs via EHome protocol. Click Save to
save the
sengs.
Center Group
Select a center group from the drop-down list.
Main Channel
The device will communicate with the center via the main channel.
Note
N1 refers to wired network.
9.9 Network Center Parameters Sengs
You can set the nofy surveillance center, center's IP address, the port No., the protocol (EHome),
the EHome account user name,etc. to transmit data via EHome protocol.
On the Device for Management page, click Remote
Conguraon → Network → Network Center
Parameters to enter the Network Center Parameters
Sengs tab.
Select a center from the drop-down list.
DS-K1T804B Series Fingerprint Access Control Terminal User Manual
124

HIKVISION DS-K1T804B Series Specifications

General

Brand	HIKVISION
Model	DS-K1T804B Series
Category	IP Access Controllers
Language	English