HIKVISION DS-K1T804B Series - Page 99

Steps
1. Click Access Control → Advanced
Funcon → Authencaon to enter the authencaon mode
conguraon page.
2. Select a card reader on the
le to congure.
3.
Set card reader authencaon mode.
1) Click Conguraon.
Figure 8-3 Select Card Reader Authencaon Mode
Note
PIN refers to the PIN code set to open the door. Refer to Congure Access Control
Informaon .
2) Check the modes in the Available Mode list and they will be added to the selected modes
list.
3) Click OK.
Aer selecng the modes, the selected modes will display as icons with dierent color.
4. Click the icon to select a card reader
authencaon mode, and drag the cursor to draw a color
bar on the schedule, which means in that period of me, the card reader authencaon is valid.
5. Repeat the above step to set other
me periods.
DS-K1T804B Series Fingerprint Access Control Terminal User Manual
84