ERT-F2xxx DVR User Manual
UM ERT-F2xxx 030118NA 104
Enter the RTSP port in the text field of RTSP Port. The default RTSP port is 554, and you can change it
according to different requirements.
• Server Port and HTTP Port: Enter the Server Port and HTTP Port in the text fields. The default Server
Port is 8000 and the HTTP Port is 80, and you can change them according to different requirements.
The Server Port should be set to the range of 2000-65535 and it is used for remote client software
access. The HTTP port is used for remote IE access.
Configure More Settings
Click Apply to save and exit the interface.
Configuring E-Mail
Purpose:
The system can be configured to send an e-mail notification to all designated users if an alarm event is
detected, etc., an alarm or motion event is detected or the administrator password is changed.
Before configuring the e-mail settings, the DVR must be connected to a local area network (LAN) that
maintains an SMTP mail server. The network must also be connected to either an intranet or the Internet
depending on the location of the e-mail accounts to which you want to send notification.
Go to Menu > Configuration > Network.
Set the IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway, and Preferred DNS Server in Network Settings.
To Next Page
Loading...
Need help?
General