ERT-F2xxx DVR User Manual
UM ERT-F2xxx 030118NA 111
Exporting Network Packet
Purpose:
By connecting the DVR to a network, the captured network data packet can be exported to a USB flash disk,
SATA, DVD-R/W, or other local backup device.
Go to Menu > Maintenance > Net Detect.
Click the Network Detection tab to enter the Network Detection interface.
Select the backup device from the Device Name drop-down list, as shown in Figure 9-22.
Click Refresh if the connected local backup device cannot be displayed. If the backup device cannot
be detected, check whether it is compatible with the DVR. Format the backup device if the format is
incorrect.
Export Network Packet
Click Export to start exporting.
After exporting is complete, click OK to finish the packet export, as shown in Figure 9-23.
Packet Export Attention
Up to 1 MB of data can be exported each time.
Checking the Network Status
Purpose:
You can check the network status and quick set the network parameters in this interface.
Click Status on the lower-right corner of the page.
To Next Page
Loading...
Need help?
General