ERT-F2xxx DVR User Manual
UM ERT-F2xxx 030118NA 108
External Port Settings Dialog Box
3. Click Apply to save the settings.
4. You can click Refresh to get the latest port mapping status.
UPnP™ Settings Finished-Manual
• Manual Mapping
If your router does not support the UPnP
™
function, perform the following steps to map the port manually.
Before You Start:
Make sure the router supports configuring the internal port and external port in the Forwarding interface.
Go to Menu > Configuration > Network.
Select NAT to enter the port mapping interface.
Leave the Enable UPnP checkbox unchecked.
Click to activate the External Port Settings dialog box. Configure the external port no. for server
port, http port, RTSP port, and https port respectively.
The value of the RTSP port no. should be 554 or between 1024 and 65535, while the value of the
other ports should be between 1 and 65535, and the values must differ from each other. If multiple
devices are configured for the UPnP™ settings under the same router, the value of the port no. for
each device should be unique.
To Next Page
Loading...
Need help?
General