4.6 Head or Knee Drive Screw
Chapter 4: Removal, Replacement, and Adjustment Procedures
Century+™ Bed Service Manual (man241) Page 4 - 23
4
3. Attach the drive screw to the bed frame with the two hairpins (C).
4. Install the head or knee motor, as applicable (see “Head or Knee Motor” on
page 4-18).
5. If applicable, connect the battery backup (see “Battery Backup Box” on
page 4-8).
6. Remove the bed stands or 2 x 4s from the bed frame, as applicable.
7. Plug the bed into an appropriate power source.
WARNING:
Powered bed mechanisms can cause serious injury. Operate the bed
only with persons clear of mechanisms.
8. Test the motor functions to ensure that the bed is working properly.
Adjustment
None
To Next Page