Final Actions
Chapter 2: Troubleshooting Procedures
Century+™ Bed Service Manual (man241) Page 2 - 7
2
11. Press the bed down switch, and activate the hilow function on the bed. The
bed lowers when the bed down switch is activated.
Yes No
↓→Go to RAP 2.7.
12. With the knee lockout switch on, press the head up switch, and activate the
head section up and automatic contour function. The head section and knee
section raise when the head up switch is activated.
Yes No
↓→Go to RAP 2.8.
13. With the knee lockout switch on, press the head down switch, and activate
the head section down and automatic contour function. The head section
and knee section lower when the head down switch is activated.
Yes No
↓→Go to RAP 2.9.
14. When the bed is in the high position, activate the Trendelenburg control
lever and the bed down switch. The bed goes into the Trendelenburg
position.
Yes No
↓→Go to RAP 2.10.
15. When the bed is in the high position, activate the Reverse Trendelenburg
control lever and the bed up switch. The bed goes into the Reverse
Trendelenburg position.
Yes No
↓→Go to RAP 2.10.
Final Actions
1. Complete the required preventive maintenance procedures. See
“Preventive Maintenance Checklist” on page 6-8.
2. Remove any bed stands or 2" x 4"s, as applicable.
3. Plug the bed into an appropriate power source, as applicable.
4. Complete all required administration tasks.
To Next Page
Loading...
