Hill-Rom Century+ P1400 - Replacement

4.7 Hilow Motor
Chapter 4: Removal, Replacement, and Adjustment Procedures
Century+™ Bed Service Manual (man241) Page 4 - 25
4
Figure 4-7. Hilow Motor
9. Using the T25 Torx® head screwdriver, remove the screw (B), and
disconnect the ground strap (C).
10. Using the 7/16" socket and ratchet, remove the bolts (D), nuts (F), spacers
(E), and washers (G).
11. Pull the hilow motor off the end of the drive shaft, and remove it from the
bed.
Replacement
1. Push the hilow motor onto the end of the drive shaft, ensuring that the drive
shaft is engaged.
2. Secure the hilow motor with the bolts (D) and nuts (F), being sure to
include the spacers (E), and washers (G).
3. Using the T25 Torx® head screwdriver, attach the ground strap (C) with
the screw (B).
m241_124