4.17 Siderails
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 56 Century+™ Bed Service Manual (man241)
Figure 4-17. Siderails
7. Using the T25 Torx® head screwdriver, remove the screw (B) securing the
ground strap to the bed frame.
8. Using the wire cutters, cut the wire ties (D) securing the cable to the bed
frame.
9. Using the T25 Torx® head screwdriver, remove the two screws (C), and
separate the siderail from the bed.
Replacement
1. Place the siderail in the correct position on the bed, and secure it to the bed
frame with the screws (C).
2. Secure the ground strap to the bed frame with the screw (B).
3. If applicable, connect the head end siderail control cable (A).
4. Secure the siderail control cable to the bed frame with the wire ties (D).
m241_115
To Next Page