Graphical Caregiver Interface (GCI)® Controls
36 Progressa® Bed Instructions for Use (171528 REV 9)
3. Press History. Follow the on-screen instructions.
– Press the dots to view more information about previously saved weights.
Zero/Tare the Scale or New Patient
The Zero/Tare function lets the
caregiver reset the scale system
before a new patient uses the bed.
1. Remove equipment and
accessories from the bed.
2. Make sure the bed is in the
correct position for Zero/Tare.
Refer to
“Recommended bed
Position to Weigh a Patient and
Required Bed Position to
Zero/Tare the Bed” on page 35.
3. Press the Scale control on the
GCI home screen.
4. Press Zero/Tare.
5. Press:
– New Patient
• Erases Scale History (all
previously recorded
patient weights will be
erased)
• Zeroes the scale
• Returns the surface to
Normal mode
• Turns off all RemindMe
reminders
or
– Zero/Tare
•Does not erase Scale
History
• Zeroes/Tares the scale
After the scale is zeroed/ tared, and the empty bed is in a stable position, a green indicator with
+/- 0,25 e Zero/Tare will appear on the Scale screen. This indicates the bed has an acceptable zero/tare.
Once there is weight in the bed this indicator will not show. If there is an unstable equilibrium +/- 0,25 e
Zero/Tare indicator will also not show. If the empty bed has been zeroed/tared, is in a stable position,
and the indicator is not on, the bed will need to be re-zeroed/tared.
To Next Page
Loading...
Need help?
General
