EasyManuals Logo

Hillrom Progressa P7500 User Manual

Hillrom Progressa P7500
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
Bed Frame Features
40 Progressa® Bed Instructions for Use (171528 REV 9)
BED FRAME FEATURES
This section describes general features found on the bed. Not all features listed are present on all beds.
POINT-OF-CARE® BRAKE AND STEER SYSTEM
The Point-of-Care® Brake and Steer System pedals are located: above the foot-end casters (brake), the
sides of the bed (steer), and at the head-end of the bed (brake and steer). At the head-end of the bed,
the brake pedal is on the left, and the steer pedal is on the right.
Use the steer mode to help move the bed in a straight line and maneuver through hallways.
Use the brake feature to keep the bed from moving.
Use the neutral position to move the bed sideways in a room or small enclosed area.
There are three steer systems available on the bed: Corner Steer, 5
th
Wheel, and IntelliDrive® Transport
System.
To Activate
Corner Steer: The left foot-end caster locks in-line ready for system movements.
5th Wheel: When the brake and steer pedal is placed in steer, the front casters are not locked into steer
mode. All four casters on the bed are put into the neutral position. This allows the bed to pivot on the
5th wheel. Pivoting on the 5th wheel, allows for tighter turns, and enhanced ease of steering.
IntelliDrive® Transport System: Steer mechanism operates as above in 5th wheel only with a power
drive wheel.
When the bed is connected to AC power and the brakes are not set, an alarm sounds and a message
shows on the GCI. When AC power is removed, the alarm will stop and the GCI will turn off.
WARNING:
Warning—Unless transporting the patient, always set the brakes. Make sure the brakes are set before
and after any patient transport. Failure to do so may cause injury or equipment damage.
Brakes—Step down on the
orange Brake Pedal.
.
Push and pull on the bed
to make sure that the brake
function is fully engaged.
Steer—Step down on the
green Steer Pedal.
Neutral Position—Move the
Brake/Steer Pedal to the level
position.
The bed can now be moved
in any direction.
The left foot-end caster
locks in-line.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hillrom Progressa P7500 and is the answer not in the manual?

Hillrom Progressa P7500 Specifications

General IconGeneral
BrandHillrom
ModelProgressa P7500
CategoryMedical Equipment
LanguageEnglish

Related product manuals