Bed Frame Features
58 Progressa® Bed Instructions for Use (171528 REV 9)
If the bed is in motion and it encounters an
obstacle:
The bed will stop lowering, and then raise
automatically for 2 seconds. The GCI will show
the location of the obstruction as left or right
side of the bed.
BED UP/DOWN—FOOT CONTROLS
The bed height foot controls are located on both
sides of the base frame, near the foot-end casters.
This feature times out after 15 seconds.
To Activate
1. With your toe, lift up on the blue switch on the
bottom of the foot control until you hear a beep
(approx. 3 seconds).
• If you release the blue switch before you hear the beep, three beeps will sound and a message
will show on the GCI with instructions to enable the foot controls.
2. With your foot, press down on the bed up or bed down control, as applicable.
NIGHT LIGHT
There is a night light on each side of the bed, located on the base frame. The light is on continuously
when the bed is plugged into AC power.
EQUIPOTENTIAL GROUND
The Equipotential Ground is located at
the head-end of the bed, near the
power cord.
To Next Page
Loading...
