Hillrom Progressa P7500 User Manual

Surfaces
66 Progressa® Bed Instructions for Use (171528 REV 9)
Start Rotation
1. Press the Pulmonary Therapy
control on the GCI.
2. Select Rotation.
3. Select Full, Moderate,
Minimum or Custom.
4. Training: Yes/No (Starts
rotation at 50% of maximum
programmed turn and
increases 10% each hour for
patient acclimation).
5. Press Start to begin Rotation.
NOTE:
If Rotation Therapy is desired with
Bed Exit on, Bed Exit must be
turned on before Rotation Therapy
is started. Only Out of Bed Mode
will work during Rotation Therapy.
Stop Rotation
1. Press the Pulmonary Therapy
control on the GCI.
2. Press Rotation.
3. Press Stop Therapies or On
the GCI home screen, press
Stop Therapies.
Set Custom Setting
1. Press Custom or the desired
setting.
2. Press the value for the
applicable setting.
3. Move the slider bar to the
applicable setting.
4. Press Start when all settings
are correct.
The following settings can be
customized
• Right turn %: Customize the
amount of turn to the right
• Pause Time (Right, Center, Left): Amount of time in side-lying or centered position
• Left turn %: Customize the amount of turn to the left side

Hillrom Progressa P7500 Specifications

General

Brand	Hillrom
Model	Progressa P7500
Category	Medical Equipment
Language	English