Error code
(SSB2)
Details
FA00 You cannot create the GAD pair because the capacity of the volume that
has been specified as the primary volume is larger than the maximum
capacity of a GAD pair that can be created.
FA01 You cannot create the GAD pair because the volume that has been
specified as the primary volume is being used by nondisruptive migration.
FA02 You cannot create the GAD pair because the storage system cache at the
primary site is in one of the following statuses:
• One side is blocked or is transitioning to being blocked.
• One side is recovering.
• Recovering
FA03 You cannot create the GAD pair because the remote paths from the storage
systems at the primary site to the storage systems at the secondary site
are in either of the following status:
• The number of remote paths is 0 (unspecified).
• The number of remote paths is less than the minimum number.
FA04 You cannot create the GAD pair because the emulation type of the volume
that has been specified as the primary volume is not OPEN-V.
FA05 You cannot create the GAD pair because the volume that has been
specified as the primary volume is a migration volume of a product of
another company.
FA07 The pair status of the volume that has been specified as the primary
volume is not SMPL.
FA08 The pair status of the volume that has been specified as the primary
volume is not PSUS or PSUE.
FA09 There is a pinned track on the volume that has been specified as the
primary volume.
FA0A You cannot create the GAD pair because the volume that has been
specified as the primary volume is blocked.
FA0B You cannot create the GAD pair because the volume that has been
specified as the primary volume is in one of the following statuses:
• Blocked
• Being formatted
• Read only
FA0C You cannot create the GAD pair because the volume that has been
specified as the primary volume is a mainframe volume.
FA0D You cannot create the GAD pair because the virtual emulation type of the
device that has been specified as the primary volume is none of the
following: OPEN-K, 3, 8, 9, E, L, or V.
FA0E You cannot create the GAD pair because the volume that has been
specified as the primary volume is not a virtual volume of Dynamic
Provisioning or Dynamic Tiering.
FA0F The device type of the volume that has been specified as the primary
volume is not supported.
Troubleshooting
9-9
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide
To Next Page
Loading...
