Error code
(SSB2)
Details
FA10 You cannot create the GAD pair because the secondary volume is in an
unusable status.
FA12 You cannot create the pair because the GAD reservation attribute has been
set for the volume that has been specified as the primary volume.
FA13 The specified volume is being used by TrueCopy.
FA14 The specified volume is being used by Universal Replicator.
FA15 You cannot create the pair because of one of the following reasons:
• The volume that has been specified as the primary volume of GAD is a
primary volume of Thin Image which is being restored.
• The volume that has been specified as the secondary volume of GAD is
a primary volume of Thin Image.
• The specified volume is a secondary volume of Thin Image.
FA16 The specified volume is a secondary volume of ShadowImage.
FA17 The specified volume is being used by Volume Migration.
FA18 The specified volume is a volume of a ShadowImage pair that is in the
process of reverse copying.
FA1B You cannot create the GAD pair because the information about the virtual
storage machine at the primary site disagrees with the one at the
secondary site.
FA1C The access attribute set by Data Retention Utility for the primary volume
cannot be transferred to the secondary volume because Data Retention
Utility is not installed in the storage system at the secondary site.
FA1D You cannot create the GAD pair by using the specified secondary volume
because of either one of the following two reasons:
• The specified secondary volume is already used for the other GAD pair.
• The information about the GAD pair still remains only in the secondary
volume.
FA1E You cannot create the GAD pair because the primary volume is a command
device.
FA1F You cannot create the GAD pair because the secondary volume is a
command device.
FA29 You cannot create the GAD pair because the volume that has been
specified as the secondary volume is not installed or is a command device.
FA2A You cannot create the GAD pair because the volume that has been
specified as the secondary volume is in the intervention-required condition.
FA2B You cannot create the GAD pair because the volume that has been
specified as the secondary volume is blocked.
FA2C The secondary volume is in an unusable status.
FA30 The pair status of the volume that has been specified as the secondary
volume is not PSUS or PSUE.
FA31 The pair status of the volume that has been specified as the secondary
volume is not SMPL.
9-10
Troubleshooting
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide
To Next Page
Loading...
