Error code
(SSB2)
Details
• The pool containing the specified volume is being initialized.
FC25 You cannot create a pair at the secondary site for one of the following
reasons:
• The capacity of the volume to be paired with the specified volume is
being expanded.
• The pool of the volume paired with the specified volume is being
initialized.
• The virtual LDEV ID of the volume to be paired with the specified
volume is duplicated in the virtual storage machine.
• You specified the virtual LDEV ID at the primary site the same as the
actual LDEV ID at the secondary site from the volume to be paired with
the specified volume. However, the actual information of the virtual
emulation type (including the settings for CVS and LUSE) or the virtual
SSID is different from the virtual information.
• The virtual LDEV ID of the volume to be paired with the specified
volume is already in use.
FC26 You cannot create a pair because verification of the remote path between
storage systems failed in the storage system of the specified volume.
FC27 You cannot create a pair because verification of the remote path between
storage systems failed in the storage system of the volume to be paired
with the specified volume.
FC28 You cannot create a pair for one of the following reasons:
• The mirror count for a single volume is depleted for the specified
volume.
• The specified volume is already being used by another GAD pair.
• The pair management table of the specified volume is depleted.
FC29 You cannot create a pair for one of the following reasons:
• The mirror count for a single volume is depleted for the volume to be
paired with the specified volume.
• The volume to be paired with the specified volume is already being
used by another GAD pair.
• The pair management table of the volume to be paired with the
specified volume is depleted.
FC30 The pair resynchronization or swap resync was rejected for one of the
following reasons:
• The pair status of the volume specified for the pair resynchronization is
not PSUS or PSUE.
• The volume specified for the pair resynchronization is not the primary
volume of the GAD pair.
• The I/O mode of the volume specified for the pair resynchronization is
Block.
• The pair status of the volume paired with the volume specified for the
swap resync is not PSUS or PSUE.
• The I/O mode of the volume paired with the volume specified for the
swap resync is not Block.
9-14
Troubleshooting
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide
To Next Page
Loading...
