Hitachi G1000 - Page 233

Error code
(SSB2)
Details
FBEA The command operating on the GAD pair was rejected because the -RB
option was specified for the pairsplit command.
FBEB The command operating on the GAD pair was rejected because the -SM
block or -SM unblock option was specified for the pairsplit command.
FC10 The command was rejected because the storage system of the specified
volume is in one of the following states:
• The storage system includes microcode that does not support GAD.
• No GAD program products are installed.
• No shared memory for GAD has been added.
If none of the above applies, contact Hitachi Data Systems customer
support.
FC12 The same operation or a different operation is already being executed.
FC13 An operation to suspend the pair is being processed because an error was
detected.
FC20 You cannot create a pair for one of the following reasons:
• The differential bit area of the storage system of the specified volume
is depleted.
• No shared memory is installed in the storage system of the specified
volume.
• No Resource Partition Manager license is installed in the storage
system of the specified volume.
• The GAD license capacity in the storage system of the specified volume
is insufficient.
FC21 You cannot create a pair for one of the following reasons:
• The differential bit area of the storage system of the volume to be
paired with the specified volume is depleted.
• No shared memory is installed for the differential bit area of the
storage system of the volume to be paired with the specified volume.
• No Resource Partition Manager license is installed in the storage
system of the volume to be paired with the specified volume.
• The GAD license capacity in the storage system of the volume to be
paired with the specified volume is insufficient.
FC22 You cannot create a pair for one of the following reasons:
• The pair status of the specified volume is not SMPL.
• The specified volume is a single volume or is not the primary volume in
the GAD pair.
FC23 You cannot create a pair for one of the following reasons:
• The pair status of the volume to be paired with the specified volume is
not SMPL or COPY.
• The volume to be paired with the specified volume is a single volume
or is not the secondary volume in the GAD pair.
FC24 You cannot create a pair at the primary site for either one of the following
two reasons:
• The capacity of the specified volume is being expanded.
Troubleshooting
9-13
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide