Error code
(SSB2)
Details
FA46 You cannot create the GAD pair because the volume that has been
specified as the secondary volume is not a virtual volume of Dynamic
Provisioning or Dynamic Tiering.
FA49 You cannot create the pair because the serial numbers of the storage
systems on the primary volume and the secondary volume are the same.
FA4B You cannot create the pair because the GAD reservation attribute is not set
for the secondary volume.
FA4C You cannot create the pair because no virtual LDEV ID is set for the
secondary volume.
FA4D No LU path to the specified secondary volume is defined.
FA4E You cannot create the GAD pair because the capacities of the primary
volume and the secondary volume are different.
FA4F No LU path to the specified secondary volume is defined.
FA50 One of the following is incorrect:
• A primary volume parameter (port name, host group ID, LUN ID)
• A secondary volume parameter (port name, host group ID, LUN ID)
FA5B You cannot create the GAD pair because the remote paths from the storage
system at the primary site to the storage system at the secondary site are
in one of the following states:
• The number of remote paths is 0 (unspecified).
• The requirement for the minimum number of paths is not met.
FA60 You cannot create a pair because the remote storage system product or its
microcode version does not support the global-active device functionality.
FA62 You cannot create the GAD pair because no virtual LDEV ID is set for the
volume specified as the primary volume.
FB80 The command operating on the GAD pair was rejected because the -fg
option was specified for the paircreate or pairresync command.
FBB0 A request to delete the GAD pair was received, but the pair cannot be
deleted because the volume paired with the specified volume is shared with
ShadowImage.
FBB1 A request to delete the GAD pair was received, but the pair cannot be
deleted because the volume paired with the specified volume is shared with
Thin Image.
FBE0 The command operating on the GAD pair was rejected because the -f data
or -f status option was specified for the paircreate or pairresync command.
FBE1 The command operating on the GAD pair was rejected because the -SM
block or -SM unblock option was specified for the paircreate or pairresync
command.
FBE8 The command operating on the GAD pair was rejected because the -P
option was specified for the pairsplit command.
FBE9 The command operating on the GAD pair was rejected because the -rw
option was specified for the pairsplit command.
9-12
Troubleshooting
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide
To Next Page
Loading...
