● Transmission Sequences 6-25
Character size
5×5
5×8（5×7）
9×8（9×7）
7×10
12×16
18×24
24×32
Inter-character space
0 to 3 dots
0 to 3 dots
0 to 7 dots
0 to 3 dots
0 to 4 dots
0 to 6 dots
0 to 8 dots
24×32
×
×
◯
×
◯
◯
◯
◯
Maximum number of vertical dots
20 dots
32 dots
¡
The total number of vertical dots cannot exceed the limit.
Machine type
Two lines machine
Four lines machine
¡
Some characters cannot be entered depending on the character size. If a print
item contains an unavailable character after a character size change, its contents
are changed to a space.
Input character types available for various character sizes
Katakana（*1）
Katakana（*2）
Alphanumeric symbols
Dedicated characters
User pattern characters
Punctuation characters
Special characters
Arabic characters
5×5
×
×
◯
×
◯
◯
×
×
5×8
◯
×
◯
◯
◯
◯
◯
◯
9×8
×
×
◯
×
◯
◯
◯
×
7×10
◯
×
◯
◯
◯
◯
◯
×
12×16
×
◯
◯
×
◯
◯
◯
◯
18×24
×
◯
◯
×
◯
◯
◯
◯
（*1）No voiced-sound or p-sound characters exist. The symbols "゛" and "
。
" are
used to form a two-digit character.
（*2）Voiced-sound and p-sound characters exist.
¡
If an inter-character space other than "0" is transmitted for a print item for which bar
code setup is completed, a communication error occurs.
d）Bar code use and bar code type
¡
Two or more bar code types cannot coexist. When a bar code is set up for a certain
print item, the same bar code is set up for the other print items for which bar code
setup was completed.
¡
For a print item for which bar code setup is not completed, you cannot set a "bar
code type" only while omitting a "bar code use" message.
¡
When bar code setup is completed for a print item, its inter-character space is set to
"0" without regard to its actual setting. (The inter-character space value "0" need not
be transmitted in this case.)
c）Character size and inter-character space
¡
The available inter-character space varies with the character size.
The "Arabic
characters" can not
used in " Simple
Chinese".
b） Line spacing
¡
When you transmit one-line setup data for a certain print item, you have to
transmit a line spacing setting of "0" as well as for the same chain as the one-line
setup data.
If you do not transmit an line spacing setting of "0", a communication error occurs.
¡
Ensure that the same line spacing setting is selected for print items belonging to
the same column. In other words, when you transmit a new line spacing setting
for a print item in a certain column, you must consecutively transmit the same
setting to the other print items in the same column.
To Next Page
Loading...
