i
Honeywell 35 Series Network Video Recorder User Guide
Cautions and Warnings
Installation and servicing should be performed only by
qualified and experienced technicians to conform to all
local codes and to maintain your warranty.
Use only with the supplied power cable.
Power output: HN350401xx for 45W and HN350802xx/
HN351602xx for 130W, PoE 802.3at/af in total.
The Honeywell product uses a 3.3V CR2032 lithium
battery as the power supply for its internal real-time clock
(RTC). Low battery power affects the operation of the
RTC, causing it to reset at every power-up.
Risk of explosion if the battery is incorrectly replaced.
Dispose of used batteries according to local regulations or
the battery manufacturer's instructions.
Make sure the product is power-down before removal.
Then carefully remove the battery.
Replace only with an identical battery or a battery which
is recommended by Honeywell.
Regulatory Statements
FCC Compliance Statement
Information to the User: This equipment has been tested and found to
comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
To Next Page
Loading...
Need help?
General
