Honeywell 35 Series Network Video Recorder User Guide
57
The Alarm In interface is displayed.
Figure 69 Alarm In
2. Set Alarm-in Port channel number and then select the enable check
box to enable the function.
3. Configure parameters.
Table 19 Alarm-in Port Parameters
Parameter Description
Alarm in
Select a port to set alarm, the alarm device is also connected to the
correspond port.
Enable alarm in
Check the box to enable the function.
Normal state N/O (normal open) or N/C (normal close).
Port name
Input the port name, the name will show on the alarm information
message.
Event Actions Refer to Table 17
Schedule
Define a period during which the alarm is active. For details, see Motion
Detection.
4. Click APPLY.
Camera Alarm In
After connecting the alarm device to the channel camera alarm input port,
system can trigger the corresponding alarm operations when there is
alarm signal from the alarm input port of camera.
1. Go to Main Menu > Event > Alarm In > Camera Alarm In.
The Camera Alarm In interface is displayed.
To Next Page
Loading...
Need help?
General
