Honeywell 35 Series User Manual

Honeywell 35 Series Network Video Recorder User Guide
64
Table 24 Port Parameters
Parameter Description
HTTP Port
The default value setting is 80. You can enter the value according to your
actual situation.
If you enter other value, for example 70, you should enter 70 after the IP
address when logging in the Device by browser.
HTTPS Port
HTTPS communication port. The default value setting is 443. You can
enter the value according to your actual situation.
RTSP Port
The default value setting is 554. You can enter the value according to
your actual situation.
Control port
The default value setting is 30413. You can enter the value according to
your actual situation.
3. Click APPLY to complete the settings.
POE
This function is only applicable for PoE NVR.
1. Go to Main Menu > Networks > Networks > POE.
Figure 78 POE
2. The default Auto manage for PoE camera is open. Users can set the
PoE camera IP parameters manually.
3. Click APPLY to complete the settings.
Note:
When the camera via POE, and the auto manage for POE camera is
enabling, icon can be shown in channel list.
The PoE parameters are modified and the device will reboot.

Honeywell 35 Series Specifications

General

Video Compression	H.264
Night Vision	Yes
Power Source	Wired
Motion Detection	Yes
Storage	MicroSD card (up to 128GB)
Weather Resistance	Yes
Lens	2.8mm