Honeywell 35 Series Network Video Recorder User Guide
69
Figure 84 Email Interface
2. Configure the settings for the email parameters.
Table 26 Email Parameters
Parameter Description
SMTP server Enter the address of SMTP server of sender’s email account.
SMTP server port
Enter the port value of SMTP server. The default value setting is
25. You can enter the value according to your actual situation.
Username
Enter the username and password of sender’s email account.
Password
Email sender Enter the email address of mail receiver(s).
Alarm Receivers
Enter the emails of receivers that you want to receive the
notification. The Device supports up to three mail receivers.
SSL encryption
Select the encryption type: Off, SSL, or Starttls.
For SMTP server, the default encryption type is OFF.
Sending Interval(0-600s)
This is the interval that the system sends an email for the same
type of alarm event, which means, the system does not send
emails caused by frequent alarm events.
The value ranges from 0 to 600. 0 means that there is no interval.
TEST
Click TEST to test the email sending function. If the configuration
is correct, the receiver’s email account will receive the email.
Before testing, click Apply to save the settings.
3. Click APPLY to complete the settings.
P2P
P2P is a kind of convenient private network penetration technology. You do
not need to apply for dynamic domain name, doing port mapping or
deploying transit server. You can add NVR devices through the below way
to achieve the purpose of managing multiple NVR devices at the same
time.
To Next Page
Loading...
Need help?
General
