Honeywell 35 Series - Figure 100 Time Zone; Figure 101 DST

To Next Page

To Previous Page

Honeywell 35 Series Network Video Recorder User Guide

Figure 100 Time zone

2. Choose time zone from the drop-down list.

3. Click APPLY to save settings.

DST

1. Go to Main Menu > System > General > DST.

2. Enable the daylight saving time function.

Figure 101 DST

3. Configure the start time and end time for the DST. For the start time,

the time will delay one hour (or half hours, it depends on the local

rules).

4. Click APPLY to save settings.

Note:

The DST setting will affect the recording time, the start time will null one

hour (half hours). The end time will have two parts recording.

Main Page

Table of Contents9
About this Document16
Overview of Contents16
Introduction17
Overview17
Key Features17
Network Video Recorder Components19
Front Panel and Rear Panel19
Figure 1 Front Panel (Hn350401Xx)19
Table 2 NVR Front Panel Description (Hn350401Xx)19
Figure 2 Rear Panel (Hn350401Xx)20
Table 3 NVR Rear Panel Description (Hn350401Xx)20
Figure 3 Front Panel (HN35040100N & HN35080100N)21
Figure 4 Rear Panel (HN35040100N & HN35080100N)21
Table 4 NVR Front Panel Description (HN35040100N & HN35080100N)21
Table 5 NVR Rear Panel Description (HN35040100N & HN35080100N)22
Figure 5 Front Panel (Hn350802Xx)23
Figure 6 Rear Panel (Hn350802Xx)23
Table 6 NVR Front Panel Description (Hn350802Xx)23
Table 7 NVR Rear Panel Description (Hn350802Xx)23
Figure 7 Front Panel (Hn351602Xx)24
Table 8 NVR Front Panel Description (Hn351602Xx)24
Figure 8 Rear Panel (Hn351602Xx)25
Table 9 NVR Rear Panel Description (Hn351602Xx)25
Figure 9 Front Panel (HN35160200N)26
Figure 10 Rear Panel (HN35160200N)26
Table 10 NVR Front Panel Description (HN35160200N)26
Table 11 NVR Rear Panel Description (HN35160200N)26
Mouse Operation27
Table 12 Mouse Operation Instruction27
Getting Started29
Unpacking the NVR29
Connecting External Devices29
Devices Connection30
Figure 11 Devices Connection (Hn350401Xx)31
Figure 12 Devices Connection (HN35040100N/HN35080100N)31
Figure 13 Devices Connection (Hn350802Xx)32
Figure 14 Devices Connection (Hn351602Xx)32
Starting and Shutting down the NVR33
Starting the NVR33
Shutting down the NVR33
Figure 15 Devices Connection (HN35160200N)33
Device Initialization34
Figure 16 Device Activation34
Figure 17 Question (Recovery the Password)35
Figure 18 Set Pattern Unlock35
Device Wizard36
Figure 19 Recover the Password36
Figure 20 Startup Wizard36
Figure 21 Network37
Figure 22 Setup Wizard - Date and Time37
Figure 23 Setup Wizard -Time Zone38
Figure 24 Setup Wizard -DST38
Figure 25 Setup Wizard -Camera39
Figure 26 Setup Wizard - Disk39
Resetting Password40
Enabling Password Reset Function40
Figure 27 Setup Wizard - Resolution40
Resetting Password on Local Interface41
Figure 28 Reset Password41
Figure 29 Password Reset 141
Home Page42
Two-Way Talk42
Device-End to IPC42
Figure 30 Password Reset 242
Figure 31 Alarm Status42
IPC-End to the Device-End43
Figure 32 Enable Two-Way Talk43
Figure 33 Device to IPC43
Figure 34 IPC to Device44
Local Basic Operation45
Configuring Camera45
Camera45
Figure 35 Add Camera46
Figure 36 Manually Add Devices47
Table 13 Remote Channel Parameters47
Figure 37 Update Interface48
Figure 38 Select File49
Figure 39 Operating Online Channel50
Figure 40 Protocol Management50
Encode51
Figure 41 Encode51
Table 14 Audio/Video Parameters51
Sensor Setting52
Figure 42 Image52
Osd53
Figure 43 OSD53
Table 15 Image Parameters53
POE Status54
Configuring Storage Settings54
Record Schedule54
Figure 44 Poe Status54
Figure 45 Record Schedule55
Figure 46 Record Type55
Disk56
Figure 47 Set Period by Drawing56
Storage Mode57
Figure 48 Disk Interface57
Disk Detection58
Figure 49 Storage Mode58
Figure 50 S.M.A.R.T Interface58
Disk Calculation59
Figure 51 Disk Detection Interface59
Ftp60
Figure 52 Disk Calculation60
Figure 53 Computation Time60
Figure 54 FTP61
Table 16 FTP Parameters61
Configuring Events Settings62
General62
Figure 55 General Page62
Motion Detection63
Figure 56 IO Control Push63
Figure 57 Motion Detection64
Table 17 Motion Detection Parameters64
Figure 58 Copy Dialog Box65
Figure 59 Region Setting66
Figure 60 Schedule Setting66
Figure 61 Smart Motion67
Figure 62 Smart Motion - Detection Area68
Figure 63 Smart Motion - Schedule68
Table 18 Detection Area Setting Parameters68
Camera Tampering69
Video Loss69
Figure 64 Camera Tamper69
Intelligent Analysis70
Figure 65 Video Loss70
Figure 66 Intrusion71
Figure 67 Multi Loitering71
Alarm in72
Figure 68 Crowd Detection72
Figure 69 Alarm in73
Table 19 Alarm-In Port Parameters73
Abnormal Events74
Figure 70 Camera Alarm in Port74
Figure 71 Abnormal Events74
Alarm out75
Figure 72 Alarm out75
Table 20 Abnormal Alarm Parameters75
Table 21 Alarm out Parameters75
Local Intelligent Analysis76
Figure 73 Local Intelligent Analysis76
Table 22 Local Intelligent Analysis Parameters76
Configuring Network Settings77
Figure 74 Intrusion Event Actions77
Figure 75 Detection Area77
Network78
Figure 76 Networks - IP78
Table 23 IP Parameters78
Figure 77 Port Interface79
Figure 78 POE80
Table 24 Port Parameters80
Figure 79 Ipv4Cctv81
Ddns82
Figure 80 802.1X Interface82
Figure 81 DDNS Interface82
Port Mapping83
Figure 82 Port Mapping Interface83
Table 25 Port Mapping Parameters83
Email84
Figure 83 NAT Port Interface84
P2P85
Figure 84 Email Interface85
Table 26 Email Parameters85
Figure 85 P2P Interface86
IP Filter87
Figure 86 P2P Operation87
Figure 87 P2P Operation87
Snmp88
Figure 88 Add IP to Filter88
Figure 89 Snmpv1/289
Figure 90 SNMPV389
Table 27 SNMP Parameters89
Network Traffic90
Access Platform91
Figure 91 Network Traffic Interface91
Figure 92 Access Platform Interface91
Configuring System Settings92
Information92
Figure 93 Network Status92
Figure 94 System Status92
Figure 95 Channel Status93
Figure 96 Disk Usage93
General94
Figure 97 Alarm Status94
Figure 98 System94
Figure 99 Date and Time95
Table 28 Data and Time Parameters95
Figure 100 Time Zone96
Figure 101 DST96
User Account97
Figure 102 Sync Camera Time97
Figure 103 User97
Figure 104 Edit User98
Figure 105 Add User98
Figure 106 Permission99
Table 29 Add Interface Parameters99
Figure 107 Advance Setting100
Figure 108 Advance Setting100
Security Center101
Figure 109 Input Security Code on App101
Figure 110 Password102
Figure 111 Security Question102
Layout103
Figure 112 Security Question103
Figure 113 Layout103
Logs104
Figure 114 Logs -System Log104
Maintenance105
Figure 115 Event Log Interface105
Figure 116 Maintenance Interface105
Figure 117 Maintenance Interface106
Configuring Live View Settings107
Live View107
Figure 118 Network Packet Capture Interface107
Figure 119 Live View Interface108
Table 30 Navigation Bar Icons108
Live View Control Interface109
Figure 120 Manual Alarm109
Figure 121 Event List Pop-Up Window109
Figure 122 Live View Control Bar110
Figure 123 Instant Replay Interface110
Table 31 Live View Control Icons110
Figure 124 PTZ Control Panel111
Table 32 PTZ Control Panel Parameters111
Figure 125 Add Tour Panel112
Figure 126 Digital Zoom Interface113
Figure 127 Camera Picture Parameter Interface113
Playback114
Time Interface114
Figure 128 Playback114
Picture Grid116
Figure 129 Picture Grid Interface116
Event Recording117
Figure 130 Replay Interface117
Figure 131 Event Recording Page117
Table 33 Event Recording Parameters Description117
Backup List118
Figure 132 Backup Interface118
Web Operation119
Network Connection119
Web Login120
Figure 133 Security Problem120
Web Main Menu121
Live View121
Figure 134 Login121
Figure 135 Liveview Page121
Playback122
Table 34 Liveview Icons & Parameters122
Figure 136 Playback Page123
Table 35 Playback Icons & Parameters123
Event Recording124
Figure 137 Event Recording Page124
Table 36 Event Recording Icons & Parameters124
Setting125
Figure 138 Setting Page125
Table 37 Setting Symbols125
Figure 139 IPC Login Page126
Faq127

Honeywell 35 Series - Figure 100 Time Zone; Figure 101 DST

Table of Contents

Other manuals for Honeywell 35 Series

Related product manuals