Honeywell ACM 150 - Figure 59. Editing the Order of Scan; Table 3: Scan Points Configuration

ACM 150
92
Figure 59. Editing the Order of Scan
Table 3: Scan Points Configuration
1
Decide on the scan sequence you want to use before you make any changes.
Note that points may be scanned in any sequence. If you want the ACM 150
monitor to spend more time scanning one or more critical points, you can repeat
the point(s) in the sequence. Order of Scan allows a maximum sequence of 87
entries.
2
Refer to Configuration key. This shows you which points are enabled for
scanning. If you want to scan a point that is not enabled, go to the Single Point
Configuration to allow it to.
If you are not ready to enable a point, you can put it in the sequence now and will
allow it later. To enable it later, first enable it in the Single Point Configuration.
Then, enable it in the Order of Scan.
3
If you change the scan order, you must re-enter the scan points starting with the
change you made until the new sequence is complete. Scroll down the list, as
needed, to complete all your entries.
Note that enter a sequence if you want to scan points in their numerical order.
4 After you complete your selections, press “SAVE CHANGE” to make them active.