Honeywell ACM 150 - Relay Output Control Panel; Figure 17. Typical Relay Layout

ACM 150
30
Figure 17. Typical Relay Layout
• Relay number 1 is shown.
• Typical of all 86 relays.
• See Figure 15 For layout and relay locations.
3.2.12. Relay output control panel
The Relay control panel provides both status and control. When the ACM 150 monitor
activates a relay, the corresponding LED lights remain lit until the condition clears or the
relay is reset. The 80 alarm relays have a momentary test switch active in the Front Panel
Mode. Relays 82–86 can only be tested from the computer in the Manual Mode. In other
modes, the switches are inactive.