Honeywell ACM 150 - Figure 76. Sample Valves Manual Control

ACM 150
112
10.2.4.2. Sample valve test
Diagnostics> Hardware Service>Sample valve test
All the sample valves, 1-40, may be controlled manually. The figure below shows valves
1-40.
No valves are activated when you enter this mode. Select the valve you want to activate
to open it. Valves 1 and 6 are selected in the figure shown below. This mode is a
convenient way to test any specific sample valve or all valves sequentially.
Figure 76. Sample Valves Manual Control
10.2.4.3. Relay test
Diagnostics> Hardware Service>Relay test
All the output relays may be controlled manually. The ACM 150 monitor has 40
programmable relays. The figure below shows only the first row of the menu,