Honeywell ACM 150 - Overview and Recent Scan Results; Figure 34. Alarms and Service Status Details; Figure 35. Status Bar (Manual Mode)

ACM 150
64
When an alarm, a fault, or a condition requiring service attention is detected, this display
indicates a status change:
Figure 34. Alarms and Service Status Details
Manual and Front panel are test/service modes. When they are selected, regular scanning
is interrupted, and the display changes from Automatic Mode to Manual Mode.
Figure 35. Status Bar (Manual Mode)
6.3.4. Overview and Recent Scan Results
Below is an image of Recent Scan Results. It updates as each area scan is completed,
about every 15 seconds, on a standard ACM 150 monitor. The display shows variables
that are determined by the Setup program. These variables can be updated as conditions
change (refer to Settings Menu).