Honeywell ACM 150 - Service Inspections and Procedures; Preparation for Servicing; Figure 81. Fault Simulation

ACM 150
117
10.2.5.3. Fault Simulation
Diagnostics>Software Service> Fault Simulation
For testing, communication links to external devices via Modbus/TCP output, such as a
PLC connection, the ACM 150 monitor, and higher features Fault Simulation.
1. Select a fault to simulate.
2. Press "START" to start simulating.
3. Fault simulation is running only on this screen. Press "QUIT" to stop the simulation.
Figure 81. Fault Simulation
10.3. Service Inspections and Procedures
10.3.1. Preparation for Servicing
10.3.1.1. Expendable parts on hand
Expendable parts, inspected and possibly replaced during PM servicing, should be
stocked on-site and available when needed.
10.3.1.2. Recommended spare parts
To minimize the time for repair, it is recommended that the ACM 150 monitor user stock
spare parts. You should review this with your local Honeywell service representative to
determine which spares should be stocked at your facility to support service. Refer to
Sections 10.3 and 10.4 For lists of parts.