Honeywell ACM 150 - Appendix B. Event List

ACM 150
139
Appendix B. Event list
Fault Category Event Level
Event
Code
Displayed Message Remark
Bench Fault
System Down 52
Bench Fault - ZPD value out of range on Point#
(energy: #, position: #)
(Only for PKI)
# Point area-id
# ZPD energy
# ZPD position
System Down 53 Bench Fault - Wrong data size (Only for PKI)
System Down 54 Bench Fault - Replace the desiccant of the PKI bench (Only for PKI)
Communication Fault
System Down 16 Comm Fault - Can't connect to Relay board
System Down 16 Comm Fault - Can't update Relay board
System Down 17 Comm Fault - Can't connect to Valve board
System Down 17 Comm Fault - Can't update Valve board
System Down 18 Comm Fault - Can't connect to ACM board
System Down 18 Comm Fault - Can't update ACM board
Require Service 61 Comm Fault - ALIGN operation failed (SBC)
System Down 61 Comm Fault - SCAN operation failed (SBC)
Require Service 61 Comm Fault - INFO operation failed (SBC)
Require Service 51 Comm Fault - ALIGN operation failed (Bench)
System Down 51 Comm Fault - SCAN operation failed (Bench)
Require Service 51 Comm Fault - INFO operation failed (Bench)
System Down 51 Comm Fault - Can't connect to FTIR Bench
Configuration Fault
System Down 14 Config Fault - No scan point configured
System Down 14 Config Fault - No scan sequence configured
Pump Fault
Require Service 5
Pump Fault - The secondary pump is activated.
(Cell pressure on Point# during Surge: #psi)
# Point area-id
# Cell pressure
System Down 10
Pump Fault - Check Secondary Pump
(Cell pressure on Point# during Surge: #psi)
# Point area-id
# Cell pressure
(Background Scan)
Require Service 9
Pump Fault - Check Booster Pump
(Sample pressure during Evac: #psi)
# Cell pressure