Honeywell ACM 150 - Exhaust; Figure 25. Nitrogen, CDA, and Exhaust Connections

ACM 150
50
5.3.3. Exhaust
The ACM 150 monitor exhausts the air samples through an exhaust pipe on the top.
Connect this to an exhaust duct with no flow restriction compatible with the types of gases
monitored by the ACM 150 monitor. The requirements are:
Flow Rate
12 scfm (340 lpm)
Connection
1-1/2 inches NPT thread (per Figure 25)
Figure 25. Nitrogen, CDA, and Exhaust Connections
1. Exhaust Pipe
2. Nitrogen Inlet
3. Air (CDA) Inlet
NOTE
Vent the monitor’s exhaust properly by site or legislated safety policies governing
the monitored gases, workplace safety, and environmental requirements.