Honeywell ACM 150 - Page 4

ACM 150
iv
5.2.1. Line power, 115 / 230 Volts AC ............................................................................46
5.2.2. Emergency Power-Off (EPO) option ....................................................................47
5.2.3. Lockout/Tagout (LOTO) disconnect .....................................................................47
5.2.4. International line power ........................................................................................48
5.2.5. Isolation transformer ............................................................................................48
5.2.6. Maintaining AC power ..........................................................................................48
5.3. Utility gases and exhaust piping ..................................................................................49
5.3.1. Nitrogen supply ....................................................................................................49
5.3.2. Air Supply ............................................................................................................49
5.3.3. Exhaust ................................................................................................................50
5.4. Sample tubing and filters.............................................................................................51
5.4.1. Tubing material ....................................................................................................51
5.4.2. Tubing run lengths ...............................................................................................51
5.4.3. ACM 150 tube connection points .........................................................................51
5.4.4. Sample area connections ....................................................................................52
5.4.5. Filters, check valves, and probes .........................................................................53
5.5. Wiring the outputs .......................................................................................................54
5.5.1. Access plates.......................................................................................................54
5.5.2. Relay output wiring ..............................................................................................54
5.5.3. Relay terminals and activation options .................................................................55
5.6. FTIR Bench installation ...............................................................................................57
5.7. Data interface .............................................................................................................57
5.7.1. Remote computers...............................................................................................57
5.7.2. Networks ..............................................................................................................57
5.7.3. Interfacing to PLC ................................................................................................58
5.8. Installation drawings ...................................................................................................59
6. Operation ...........................................................................................................................62
6.1. Safe and proper operation of the ACM 150 monitor ....................................................62
6.1.1. ACM 150 operating safety....................................................................................62
6.2. Computer information .................................................................................................63
6.2.1. ACM 150 touchscreen and keyboard ...................................................................63
6.2.2. Remote computer access ....................................................................................63
6.3. Status and scan results ...............................................................................................63
6.3.1. Area scanning ......................................................................................................63
6.3.2. Background .........................................................................................................63
6.3.3. Status bar ............................................................................................................63
6.3.4. Overview and Recent Scan Results .....................................................................64
6.4. Changing the mode of operation .................................................................................67