APPENDIX A - SPECIFICATIONS
A.4.6 Interpretation of nvoStatus
The object status contains a great deal of information about the status of a node. Several bits have
meaningassignedwhichisspecictoHoneywellAnalytics.
For example fault_alert (Honeywell nomenclature) has been mapped to mechanical_fault
(LonMark nomenclature).
The following table lists all of these assignments. Blank entries correspond to unimplemented
status bits.
Status Field Node 0 interpretation
object_id(16bits) 0
invalid_id object_id>1
invalid_request Unimplemented request made
disabled Network reporting inhibited
out_of_limits Warning alert active
open_curcuit
out_of_service Not in normal mode
mechanical_fault Fault alert active
feedback_failure
over_range Concentration > full scale
under_range
electrical_fault
unable_to_measure Sensor is not connected
comm_failure Error inside LIFELINE II
fail_self_test Error inside LIFELINE II
self_test_in_progress
locked_out Remote access unavailable
manual_control
in_alarm Alarm level 1 is active
in_override
report_mask nvoStatus mask report
programming_mode
programming_fail Request made could not be implemented
alarm_notify_disable Alarm reporting over network is disabled.
To Next Page
Loading...
