Honeywell Apex - Weather Housing

18
MAN0604_Issue 09_02-2013 Apex
2110M8030
2.3.4 Weather Housing
Caution: This accessory should not be used for calibration purposes.
This accessory is not recommended for use in still air conditions.
Part Number: 2110B2150
2. OVERVIEW
The Weather Housing accessory protects the sensor from hosing down/ cleaning operations and
from extreme weather conditions, (e.g. torrential rain, storms, gales etc.). Conforms to CSA C22.2
No. 152whenttedtotheCertiedSensorwithspeciccartridgesinstalled.Seespecications
for details.
Theweatherhousingshouldnotbettediftheoperatingenvironmentofthesensordoesnotrequire
the additional protection afforded. In still air conditions the gas is transported to the face of the sinter
is by diffusion only. Under such conditions the weather protection will slow the rate at which gas can
reach the sensing element and consequently the speed of response of the sensor to gas will
be reduced.
As well as providing weather protection the housing also provides a means to directly inject gas to
thefrontofthesensorviaa1/4in.O/Dnozzleforgasresponsechecking.Therecommendedow
rate for response checks is 1 litre per minute. Accuracy of reading is not guaranteed. Do not carry
outresponsechecksatwindspeedsgreaterthan10m/s(22mph).
Theaccessoryisattachedtothesensorbymeansofabayonettting.
Note: The sensor will exhibit an increased reading(or indication) to gas with higher wind speeds.
 Fittingtheweatherhousingwiththesuppliedhydrophobiclterwilleliminatethiseffectbut
increase the response time.
53mm
57mm