Codabar
Click the “Codabar” in the left list then all its related parameters will be shown on the
right.
Redundant times: output the decode result only when got identical barcodes
information for specific times.
Minimum Length: output the decode result when the symbology length equal or
larger than the minimum length.
Maximum Length: output the decode result when the symbology length equal or
shorter than the maximum length.
Transmit Start/Stop Characters: Start/Stop characters identify the leading and
trailing ends of the bar code. You may either transmit, or not transmit Start/Stop
characters.
Check Character: Codabar check characters are created using different “modulos.”
You can programthe HF800 to read only Codabar bar codes with Modulo 16 check
characters. No Check Character indicates that the HF800 reads and transmits bar
code data with or without a check character. When Check Character is set to
Validate and Transmit, the HF800 only reads Codabar bar codes printed with a
check character, and transmits this character at the end of the scanned data. When
Check Character is set to Validate, but Don’t Transmit, the HF800 only reads
Codabar bar codes printed with a check character, but does not transmit the check
character with the scanned data.
Code 93
Click the “Code 93” in the left list then all its related parameters will be shown on the
right.
To Next Page
Loading...
Need help?
General
