EAN-8
Click the “EAN-8” in the left list then all its related parameters will be shown on the
right.
Redundant times: output the decode result only when got identical barcodes
information for specific times.
Check Digit Transmit: This selection allows you to specify whether the check digit
should be transmitted at the end of the scanned data or not.
2/5 Digit Addenda: This selection adds 2 or 5 digits to the end of all scanned EAN-8
data.
Addenda Required: When Required is set, the HF800 only reads EAN-8 bar codes
that have addenda.
Addenda Separator: When this feature is On, there is a space between the data
from the bar code and the data from the addenda. When turned Off, there is no
space.
EAN-13
Click the “EAN-13” in the left list then all its related parameters will be shown on the
right.
To Next Page
Loading...
Need help?
General
